|
CHECK LIST BEFORE VACUUMING 1. CLOSE POOL.
2. Always make sure either receptacle has G.F.I. or use in line G.F.I.
3. Make sure power cord is secure and will not make contact with water.
4. Install return line and make sure hose is below surface of water.
5. Pour 4-5 lid fulls of water into strainer basket.
6. Turn switch on. System will only take 4-5* minutes to prime. (see note below)
7.When moving the Pool Weasel along pool deck be sure to :
1) Cut POWER OFF 2) UNPLUG power cord 3) Move vacuum hose and vacuum and vacuum head to desired location 4) Move hand truck to desired location 5) Plug back in, secure power cord 6) Turn power on, should take only 1/2 minute to prime
8. When cleaning strainer basket , make sure to replace lining notches with holes and make a 1/4 turn.
9. When finished vacuuming pull vacuum head out of water and allow to run 10 seconds, pulling water out of vacuum hose and canister.
10. To increase life of filter element, RINSE after each vacuuming.
11. Every few months lubricate "O" rings with Magic Lube included with your system.
12. Please call 1/800 P- Weasel for technical support.
* note: if machine doesn't prime quickly then check for the following: 1- dirty filter 2- clogged impeller 3- vacuum hose is sucking air
1/800-793-2735 1908
Sharon Lane ~ Charlotte, NC 28211 Home Products Weasel at Work Response Who We Are Customer Testimonials Faqs
|
